SMART 50M – Oil in Water Detector
The SMART 50M is a versatile and sophisticated oil-in-water detector. The monitor is designed for high temperature and high-pressure sample measurements in marine and industrial applications, across multiple ranges of oil concentration.
The monitor has two versions available to suit different oil ranges – low and medium. Combined with proprietary measuring cell, autoclean capability and auto-zeroing functionality, this oil-in water detector has minimal maintenance requirements, producing highly accurate measurements consistently, as the measuring cell is kept free from fouling.
The oil-in-water detector uses a nephelometry based detection technique and sophisticated algorithms to detect oil content in the sample stream.
An internal data recorder will log the following data – oil concentration, sample pressure, sample temperature, fault status alarm and run status.
The Smart 50M can provide the Oil Concentration value to a DCS or PLC using a 4-20mA output.
As standard the following data is available:
- Oil Concentration
- Sample Pressure
- Sample Temperature
- Fault Status
- Alarm and Run states
Applications
- Hydrocarbon Leak Detection
- Lube Oil Cooler Monitoring
- Boiler Feed Protection
Heat Exchanger Leak Detection
Industrial Wastewater/Groundwater discharge
SPECIFICATION
| Ranges: | Low range 0 – 10ppm
Medium range 0 – 200ppm |
| Accuracy: | Low range +/- 0.5ppm
Medium range +/- 5 ppm |
| Alarm 1 Operating Point: | Low range 1 – 10 ppm
Medium range 1 – 200 ppm |
| Alarm 2 Operating Point:
|
Low range 1 – 10 ppm
Medium range 1 – 200 ppm |
| Alarm 1 Operating Delay:
|
1 – 15 seconds |
| Alarm 2 Operating Delay:
|
1 – 600 seconds |
| Alarm contact rating:
|
8 AMP @230VAC |
| Output signal:
|
4-20 mA |
| Ambient temperature:
|
1-60 °C / 34 – 122 F |
| Humidity:
|
Max 98% non condensing |
| Sample temperature:
|
1 – 95 °C / 34-203 F |
| Sample Flow:
|
0.3 – 3 Ltrs per min / 0.079 – 0.79 Gal per min |
| Sample Pressure: | 1.0 Bar Minimum / 14.50 Psi
3.0 Bar Nominal / 43.50 Psi |
| Clean Water requirements: | 0.3 – 3L per min / 0.079 – 0.79 Gal per min for ‘zeroing’ |
| Weight: | 15kg / 33.07 lb |
| Size:
|
500 x 360 x 150mm / 19.7” x 14.2” x 5.9” |
| Supply voltage:
|
115 – 230 VAC |
| Power consumption:
|
15 VA |
| Degree of Protection:
|
IP56 |
| Approvals:
|
Tested to EN61010 EN61326 (CE), c UL us. |
Specifications and system descriptions accurate at time of publishing. These are subject to change.
If you have any questions about the MARPOL marine environmental regulations or the Marine Environment Protection Committee (MEPC) guidelines, please contact us either by submitting a form here using this link with your questions or email us at sales@rivertrace.com. We are always happy to help.
For more information on the MARPOL marine environmental regulations or the Marine Environment Protection Committee (MEPC) guidelines visit our Regulations section
Our services
The services we offer are focused on keeping your oil detection sensors and water monitoring systems running effectively to provide accurate data and timely alerts.
- Calibration Services
- Repairs and Replacements
- Technical Support
- System Diagnostics